254/325
Home /

getting ready to use the router

20190817_094925.jpg the t-grip after routingThumbnailspadding the blade for clampingthe t-grip after routingThumbnailspadding the blade for clampingthe t-grip after routingThumbnailspadding the blade for clampingthe t-grip after routingThumbnailspadding the blade for clamping

I clamped the paddle down at the blade & t-handle to prepare to route the shaft. A 1/2" radius round-over bit, in a Hitachi M12VC 2-1/4 HP Router, was used to turn the square profile shaft into a circular profile. A smaller palm router would probably have been easier. A router table would have worked even better.

Dimensions
4160*3120
File
20190817_094925.jpg
Filesize
5302 KB
Visits
669
Rating score
no rate
Rate this photo

0 comments