14/15
Home / Random photos /

getting ready to use the router

20190817_094925.jpg rough shaped taper on paddle bladeThumbnailsthe paddle after routingrough shaped taper on paddle bladeThumbnailsthe paddle after routingrough shaped taper on paddle bladeThumbnailsthe paddle after routingrough shaped taper on paddle bladeThumbnailsthe paddle after routing

I clamped the paddle down at the blade & t-handle to prepare to route the shaft. A 1/2" radius round-over bit, in a Hitachi M12VC 2-1/4 HP Router, was used to turn the square profile shaft into a circular profile. A smaller palm router would probably have been easier. A router table would have worked even better.

Dimensions
4160*3120
File
20190817_094925.jpg
Filesize
5302 KB
Visits
75
Rating score
no rate
Rate this photo

0 comments