1,575
edits
Changes
no edit summary
In this section we're going to move the factory Hill Assist & ATC Off switches from the Center Stack to left of the Steering Wheel, move the Cargo Lamp switch from left of the Steering Wheel to the Center Stack, replace the factory Cargo Lamp switch with an aftermarket switch, install 2 more aftermarket switches, and run cabling to make said switches do something!
#Alright, Once again, we have to remove the Driver's side kick plate, pull back the gasket, & remove the next panel up. Behind that panel you will find a Phillips Head screw you need to remove. Also remove the Philips head screw to the right of the steering wheel.<br />[[File:Yaesu_Install_Switches_1.jpg|266px]][[File:Yaesu_Install_Switches_2.jpg|266px]][[File:Yaesu_Install_Switches_3.jpg|266px]]#Now remove the entire plastic section underneath the Steering Wheel and unplug the cable running to the Cargo Lamp Switch. The switch was inserted from the back and so it comes out the same way. Lift up on the little plastic tab on the switch bracket and you'll be able to pull the switch out (through the back).<br />[[File:Yaesu_Install_Switches_4.jpg|400px]][[File:Yaesu_Install_Switches_5.jpg|400px]] #The switches in the Center Stack come out the same way. Remove the Center Stack. Unplug the ATC & Hill Start Assist swtich cables. Go in from behind and using a small screwdriver, lift the plastic tabs holding the switches in place. go ahead and remove the blank switch placeholders from both sides as well.<br />