Changes

2012 Nissan Frontier: Yaesu FT-7900R Install

442 bytes added, 21:29, 11 November 2012
no edit summary
*2x #10 flat washers
*2x #10 split (lock) washers
*a piece of scrap metal at least 1.6" x 1.6" inches square (see [[#The Antenna]])
*[https://en.wikipedia.org/wiki/Hex_key Hex Key Set]
*A Drill & a 13/62" Drill Bit
#The NMO Mount
##Drill out the 2 bottom holes on the NMO Right Angle Bracket using the 13/64" Drill Bit. This will give clearance for the 10-24 screws.
##Make a washer plate###Cut out a 1.6" x 1.6" square from a piece of scrap metal (I used a [https://en.wikipedia.org/wiki/Shear_(sheet_metal)#Guillotine Guillotine Sheet Metal Shear] for this)###Draw a line across the center of the square###Use the NMO Right Angle Bracket as guide to mark where to drill 2 holes in the square.###Drill out the 2 holes you marked off.##Collect your parts (#10-24 screws, flat washers, lock washers, washer plate, NMO
===Power===