2012 Nissan Frontier: Yaesu FT-7900R Install

This page details the installation of my Yaesu FT-7900R Dual Band (2m/70cm, 144MHz/430MHz), Mobile, Ham Radio in my 2012 (Gen2) Nissan Frontier Crew Cab. I wanted a clean, professional, looking install but I didn't want to make any permanent modifications to my vehicle. I doing this project I took advantage of my recent DIY Utili-Track.

Assumptions

1. You want a really clean looking install and are willing to put in a bit of extra work
2. You don't want to make any permenant modifications to the vehicle

Grocery List

• Yeasu FT-7900R Dual Band Mobile Transceiver
• Yaesu YSK-7800 Separation Kit
• Comet SSB-5NMO Dual Band NMO Antenna
• A right angle Trunk Mount NMO Bracket
• A 17' NMO to PL-259 RG58 Cable (Don't go too much shorter than 17'. 15' would be the absolute minimum)
• (optional) NMO Weather Cap
• Liquid Electrical Tape
• Zip Ties
• Factory Installed Utili-Track™ or a [2012_Nissan_Frontier:_Strut_Channel_Install|DIY Utili-Track]] solution.
• 2x 10-24 Spring Nuts
• 2x 10-24 Pan Head Screws (approx 1" long)
• 2x #10 flat washers
• 2x #10 split (lock) washers
• a piece of scrap metal at least 1.6" x 1.6" inches square (see #The Antenna)
• Hex Key Set
• A Drill & a 13/62" Drill Bit
• Wrench/Socket Set
• 130W+ Soldering Iron (possibly optional, see Basic Information)
• Solder
• (optional) Solder Braid
• (optional) Solder Flux

Basic Information

• If you don't know how to solder or don't have the soldering tools available you can try a cable like this Comet CK-3NMO which *SHOULD* allows you to complete the install without cutting & resoldering the NMO connector.

Directions

Click on any photograph for a larger view.

The Antenna

I chose to use an NMO type antenna because I think they are the most professional looking install. Additionally I decided to mount the antenna on my recently installed Strut Channel. This had a couple advantages: 1.) I didn't have to drill any holes in the vehicle. 2.) I could use my cool new Strut Channel :) 3.) It placed my antenna such that it is almost exactly the same height as the factory AM/FM Radio Antenna. The broad order of this install isn't too important. I chose to figure out the NMO mount 1st and the move on to running the cable.

1. The NMO Mount
   1. Drill out the 2 bottom holes on the NMO Right Angle Bracket using the 13/64" Drill Bit. This will give clearance for the 10-24 screws.
   2. Cut out a