1,575
edits
Changes
no edit summary
#<span style="color:#55E439">'''This is probably the trickest part of the whole install'''</span>: You need to drill pilot holes in your bed-liner that line up with the factory bolts on the Frontier. I basically had to eyeball my first hole. From there I measured as best I could (although this was made difficult but the uneven surface of the bed-liner) I haven't come up with a better solution but this worked for me.
##With the bed-liner pulled off (and the factory bolts in place) I eyeballed the first hole and used the smallest drill bit I had to drill a hole through the bed-liner.
##I then reinstalled the bed-liner, stuck my drill bit back in the hole, and ran it against the factory bolt for a second to, intentionally, leave a scratch mark. The 3 photos below show the results of this technique. The blue circle highlights my 1st attempt. The green circle highlights my 2nd attempt. The photo of the bedliner shows the 2 holes I drilled for the 1st location. (click for a larger image)<br />[[File:Strut_Channel_Bolt1.jpg|400px]][[File:Strut_Channel_Bolt2.jpg|400px]][[File:Strut_Channel_Bolt3.jpg|400px]]
