1,575
edits
Changes
no edit summary
#*The 3 Lid mount points that aren't shared with the Fuse Block use 8-32x3/4" Flat Head Screws with #8 Lock Washers & 8-32 Nuts.
#*The 1 hole shared by the Lid mount & the Fuse Block uses an 8-32x1.5" Pan Head Screw with a #8 Lock Washer & an 8-32 Nut.
#Now it's time to add the cabling. I'm not going to detail every single wire I ran but I will show you have I did it and give you a basic rundown. I connected all black wires (negative side of the Relay Coil) to the Barrier Strip. I connected all white wires (Positive side of the Relay Coil) to my 1st connectors. I connected the 5 red wires from the Relays (the common line) to locations 2, 3, 4, 5, & 6 on the Fuse Block. I connected the 5 blue wires from the Relays (the Normally Open line) to the 2nd connector. Additionally a red line in 12AWG was used to provide power to the dash switches which comes off the plate on pin 1 of the Switch Signal Connector.