1,575
edits
Changes
no edit summary
##Create new project
##Prepare a PROM file
##Target a #Click <span style="color:#55E439">3rd party SPI Create PROM File (PROMFile Formatter)</span>, PROM format from the <span style="color:#55E439">MCSiMPACT Flows</span>, name file and set destination as desiredpane on the upper left###Select <span style="color:#55E439">SPI PROM density as Flash... Configure Single FPGA</span> in Step <span style="color:#55E439">1</span>###Select <span style="color:#55E439">64M</span>. Leave from the <span style="color:#55E439">Storage Device (bits)</span> Drop Down & click <span style="color:#55E439">Add Data Files unchecked.Storage Device</span> in Step <span style="color:#55E439">2</span>##Finish.#Select <span style="color:#55E439">Output file Name</span>, <span style="color:#55E439">Output File Location</span>, and <span style="color:#55E439">File Format</span> in Step <span style="color:#55E439">3</span>###Click <span style="color:#55E439">OK and navigate to desired </span>###Select your <span style="color:#55E439">.bit file. Click Open, and double-</span> from the <span style="color:#55E439">Add Device</span> window that pops up##Double click <span style="color:#55E439">Generate File...</span> from the <span style="color:#55E439">iMPACT Processes</span>pane in the lower left#Turn off board power<span style="color:#55E439">OFF</span Board Power#Connect JTAG Programming Cable to <span style="color:#55E439">J10</span> as indicated by the table below{| border="1" align="center" style="text-align:center;"!<span style="color:#FF3A83">LEAD CLR</span>!<span style="color:#FF3A83">LEAD LBL</span>!<span style="color:#FF3A83">BRD J10 #</span>!<span style="color:#Connect jumper to FF3A83">BRD J10 LBL</span>|-|Red|VREF|11|VCC|-|Black|GND|9|GND|-|Yellow|TCK|7|SCK|-|Grey|HALT|||-|Purple|TDO|5|MISO|-|White|TMS|3|MOSI|-|Green|TDI|1|SEL|}#Jumper pins <span style="color:#55E439">1</span> & <span style="color:#55E439">2</span> (both pins of ) on <span style="color:#55E439">JP7</span>. Center columns of #Jumper pins <span style="color:#55E439">3</span> to <span style="color:#55E439">4</span> and <span style="color:#55E439">5</span> to <span style="color:#55E439">JP96</span> should be jumpered (<span style="color:#55E439">M1</span> & <span style="color:#55E439">M2</span>, both center columns).on <span style="color:#55E439">JP9</span>#Turn on board <span style="color:#55E439">ON</span> Board Power
#Program with iMPACT
##Open iMPACT
##Check <span style="color:#55E439">Verify</span> and <span style="color:#55E439">Erase</span> options as desired, then OK.
##Double-click Program. It takes a minute or two before the progress bar moves.
#Turn off board power<span style="color:#55E439">OFF</span> Board Power, disconnect the jumper from <span style="color:#55E439">JP7</span>.#Turn on board power<span style="color:#55E439">ON</span> Board Power